prothane total kits

[brianm@zbt62.eastnet.gatech.edu (Brian McGarvey)]

the easietr and better way to do it is to spend the extra specail low cost
pricing for the new lower control arms at < 20 each and get em already
installed.
:-)
brian
PS. that way you know they are not bent.


On Tue, 5 Mar 2002 jester@westfailure.net wrote:

> On Tue, 5 Mar 2002, Rick Kellner wrote:
>
> > Mark,
> > How difficult is it to press the control arm bushings on?  What type of
> > press and pressure is required?  Thanks.
>
> The poly ones just slide right in. your hand or maybe a tad bit of coaxing
> with a hammer.
>
> Hard part is removing the old bushings, i just use a propane torch on them
> till they are burning & wait a while.  after you wait a bit, blow them
> out & the metal part falls out & any rubber left peels right out.
>
> take care,
>
> Steve
>
>
> ***************************************************************************
>      If you see a mad professor in a minibus, just smile. --James Bond
>                       http://westfailure.org
> ***************************************************************************
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>