Re: speedo needle vibrating too much

[Nathan Malone <nmalone@sumagroup.com>]

If you haven't got anything back on this yet,
I can tell you it's very easy, just follow your
speedo cable (on the eng. side) to the end.
Unscrew it  and pull out the inside square cable.
That might just need to be cleaned, if it's kinked,
you'll need to replace it. but just that square cable,
no need to replace the whole thing, that's a little
more of a pain.When putting the new square cable
back in you'll have to manipulate it through the
housing cable alittle but it shouldn't be that bad.
Worst comes to worst  you might have to
unscrew it from behind the speedometer to manipulate
it all the way into the acceptor, but even then you can
probably do that just by feelin behind your inst. cluster
from below, depending on what car you have.

Nathan




--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org