ARP head stud questions...

[tyrone27 at gmail.com (Derrick floyd)]

dude just call ARP up and talk to them.  I talked to them yesterday because
I had 2 studs off my 16v that was messed up and they told me the thread
specs on the studs so I could get a die to repair the studs.

On 7/29/06, Dan Bubb <jdbubb@verizon.net> wrote:
>
> In the days before the low torque then tighten a specific angle, VW head
> torque is 54 ft-lb, 61 for a diesel.
> This is straight from the 1977 VW repair manual.
>
> From: "LEF" <rocco16@sbcglobal.net>
> Sent: Friday, July 28, 2006 8:15 PM
> Subject: Re: ARP head stud questions...
>
>
> I hope you are not assuming that the final torque setting for a head
> bolt/stud is 65ft/lbs.  !!!
>
> larry
> sandiego16v
>
>   So it looks like 65 ft/lb. w/ a good quality moly lube (for an
>   aluminum head) is the spec I was looking for.  I also came across some
>   advice on the net to retorque the ARP nuts after some time.
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>