[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Crankcase Breather and Coolant Temp
- Subject: Crankcase Breather and Coolant Temp
- From: haygood at myway.com (Brian Haygood)
- Date: Tue Aug 8 11:05:47 2006
Eric,
It isn't that hard to get that last hose on. Just feel around under the intake manifold near the #1 cylinder. With a breather on there it will be pulling air in that hasn't been measured by the air flow plate, so your fuel mixture will be off a little. That means you should hook it up very soon.
Brian
--- On Sun 08/06, Eric Marsden < marsden.eric@gmail.com > wrote:
From: Eric Marsden [mailto: marsden.eric@gmail.com]
To: rocco16@sbcglobal.net
Cc: Scirocco-l@scirocco.org
Date: Sun, 6 Aug 2006 21:09:45 -0400
Subject: Re: Crankcase Breather and Coolant Temp
Larry,<br><br>Thanks I think I finally got it all down except for the hose you said I need<br>a mirror for...I assume since you would need a mirror nobody has a picture<br>of this at all. Well for now the car is running good until it starts to<br>build up temp and then the cooling fan doesnt wanna come on...But thanks<br>again for the description.<br><br><br>On 7/31/06, LEF <rocco16@sbcglobal.net> wrote:<br>><br>><br>><br>> I ordered through the dealer some of<br>> > the parts for the crankcase breather on my '88 16v. I figured out<br>> > where some of the hoses go but one end heading towards the battery<br>> > seems to just end so I had to throw a generic snomobile engine<br>> > breather on the end.<br>><br>><br>><br>> The big rubber air intake duct (from fuel dist to throttle body) has<br>> three, different-sized fittings, located at 8 o'clock.<br>> The largest goes to the idle control valve. The mid-sized hose goes to a<br>> fitting on the intake<br>> manifold where
it goes into the #1 intake port (you'll need a mirror to<br>> see it). The smallest hose goes to the charcoal canister<br>> which is located in the DS fender.<br>> The large hose coming off the breather in front of the block goes to the<br>> airbox just below the filter element, after Tee'ing to the cold start<br>> injector...that's the expensive one. :)<br>><br>> larry<br>> sandiego16v<br>><br>><br>><br>><br>><br>> _______________________________________________<br>> Scirocco-l mailing list<br>> Scirocco-l@scirocco.org<br>> http://neubayern.net/mailman/listinfo/scirocco-l<br>><br>><br>><br>_______________________________________________<br>Scirocco-l mailing list<br>Scirocco-l@scirocco.org<br>http://neubayern.net/mailman/listinfo/scirocco-l<br>
_______________________________________________
No banners. No pop-ups. No kidding.
Make My Way your home on the Web - http://www.myway.com