[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
WAS: My clutch?? I thought it was my clutch...now I'm not so sure., NOW: bonehead move of the year
Thankyouverymuch.
>Are you sure your clutch cable is ok where it goes through the
>firewall? Its pretty hard to get all the pressure plate springs to
>fail at once.
>Eric
Jim Ruffi wrote:
> Ahhhh HHAHAHAHAHAHAHAHAHaHAHHHAHAHAHAHAHAHAHHAH!
>
> <sob>
>
> It was my cable. It had collapsed at the firewall. The internal cable was
> fine; the sheath collapsed.
>
> I had oil on my clutch and needed to do a steering rack boot, rear main
> seal, input shaft seal and .80 5th, but that doesn't excuse my stupidty. I
> should have looked more closely at the whole thing and seen that the release
> lever wasn't lifting enough. That won't happen again.
>
> The car should be on the road today. New trans mounts, too.
>
> Jim
>
>
>>-----Original Message-----
>>From: scirocco-l-bounces+sciroccos=earthlink.net@scirocco.org
>>[mailto:scirocco-l-bounces+sciroccos=earthlink.net@scirocco.org]On
>>Behalf Of Jim Ruffi
>>Sent: Monday, October 03, 2005 11:33 PM
>>To: Scirocco-L
>>Subject: My clutch?? I thought it was my clutch...now I'm not so sure.
>>
>>
>>Pulled the tranny, 'cause my pedal went to the floor the other
>>day. No, the
>>cable wasn't broken. You could pull the lever up at the trans very easily,
>>way past the point where you're supposed to feel resistance and the clutch
>>is supposed to disengage. But my clutch doesn't disengage.
>>
>>Knowing I had a good and connected cable, I proceeded to take the green end
>>cap off and check the arm and lever. No cracks, everything working.
>>Checked the throwout bearing for collapse. No problem there.
>>
>>Pulled the tranny, expecting to see a hole in the pushplate or a deformed
>>rod....nothing.
>>Pressure plate looks ok. Clutch worn, but looks ok. Rod is fine.
>>
>>I remember experiencing this many years ago and it being the result of a
>>pressure plate failing. Like the fingers had collapsed or something...I
>>could be mistaken....I hope that's what's going on here, as I have a new
>>clutch but no indication that it'll fix my problem.
>>
>>Your thoughts and advice is appreciated!!
>>
>>Jim
>>
>>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>