[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Engine stand usage

Subject: Engine stand usage
From: gatesj at mailblocks.com (John Gates)
Date: Tue Jul 26 14:53:20 2005
In-reply-to: <42E68FA8.4020109@kudria.com>
References: <009901c58e3a$700c7880$0100007f@localhost> <gatesj-0iSTCA3cKn6siumpp6QCVeF6KGcT/yt@mailblocks.com> <42E68FA8.4020109@kudria.com>

Good point.

-----Original Message-----
From: Mauricio Tavares <raub@kudria.com>
To: Scirocco-l@scirocco.org
Sent: Tue, 26 Jul 2005 15:31:52 -0400
Subject: Re: Engine stand usage

John Gates wrote:
> Assuming you got an answer by now but you just use the bellhousing 
bolts > to thread to the flywheel side of the motor after you take the 
flywheel > off if necessary. Bolt the stand up to the motor basically 
like the > transmission would bolt up to the motor.
> I would also add you shoul bolt the fixture to the engine and then 
attach the entire crap to the stand

_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l

References:
- Engine stand usage
  - From: ceatock at sympatico.ca (Chad Eatock)
- Engine stand usage
  - From: gatesj at mailblocks.com (John Gates)
- Engine stand usage
  - From: raub at kudria.com (Mauricio Tavares)

Prev by Date: Motor is out!!
Next by Date: poly bushing kit
Previous by thread: Engine stand usage
Next by thread: Anything to do in Germany?
Index(es):
- Date
- Thread