Engine stand usage

[gatesj at mailblocks.com (John Gates)]

Assuming you got an answer by now but you just use the bellhousing 
bolts to thread to the flywheel side of the motor after you take the 
flywheel off if necessary.  Bolt the stand up to the motor basically 
like the transmission would bolt up to the motor.

John Gates
--
'97 Jetta GLX
'85 Scirocco

-----Original Message-----
From: Chad Eatock <ceatock@sympatico.ca>
To: Sciroccolist <Scirocco-l@scirocco.org>
Sent: Thu, 21 Jul 2005 17:17:24 -0400
Subject: Engine stand usage

Hey everyone!  Just picked up an engine stand for the 1.8l.....just 
wondering
how the motor is attached to the stand?  Does it bolt to the block on 
the
flywheel side?  Or does it affix to the belt/pulley side?  I'm so green 
its
sick....but I am slowly getting the motor out of the rocco....jopefully 
I can
have it done before the end of summer!!!!

Chadster16v
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l