Lower half 16v intake same; 1.8 & 2.0?

[rfkellner at snet.net (Rick Kellner)]

Do you know if the studs will mate to the upper half, i.e. a 2.0l lower
to a 1.8l upper?
Thanks, Rick.

-----Original Message-----
From: Allyn [mailto:amalventano1@tds.net] 
Sent: Friday, July 22, 2005 1:53 PM
To: RICHARD F KELLNER; scirocco
Subject: Re: Lower half 16v intake same; 1.8 & 2.0?

I dont believe the lower/upper runners match, but it doesnt take much to

port match the smaller lower intake to the larger upper intake.
Actually, i'm not positive that the head mating end of the lower intake
is 
the same... someone else would probably chime in on that one.
hth
Al

----- Original Message ----- 
From: "RICHARD F KELLNER" <rfkellner@snet.net>
To: "scirocco" <scirocco-l@scirocco.org>
Sent: Friday, July 22, 2005 10:06 AM
Subject: Lower half 16v intake same; 1.8 & 2.0?


>
> Is the lower half of a 16V intake (40mm runners) the same for a 1.8l
head 
> and a 2.0l  (42mm runners) head?  I know they are the same at the end
that 
> mates to the head however; are they the same on the end that mates to
the 
> upper half of the intake?
>
> Thanks, Rick.
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>