[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Brake line removal/repair/replacement (something?) help
At 03:16 AM 7/21/05, Gordy Stedman wrote:
>I think my friend used some type of compression fittings to splice
>brake lines. I will find out more tomorrow.
>
>On 7/20/05, Ryan H <rhock99@epix.net> wrote:
> > My rearmost hard brake lines are leaking due to rust, so since I had to
> drop the rear beam anyway, I figured I'd replace the rubber lines with
> SS. Well, I can't disconnect the rubber line at the front and it's
> looking pretty rusted on the hard line near the connection anyway, so is
> there any way I can cut a section of the hard brake line and put in a new
> section? Like an extension of sorts. I keep thinking, ok just put on a
> female end and flare the line, but in my mind two flares just don't seem
> to match up... any ideas?
>
>
>--
>Gordy
>MK1 x 3
>Audi 80 - Slated for parts car
>
>_______________________________________________
I really hope not. Compression fittings would not be a good thing to use
on brakes. Now flare fittings
would be ok.
John
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.9.2/54 - Release Date: 7/21/05