ABA swap into MK II Scirocco

[DMaula at gordonrees.com (Denny Maula)]

Ground clearance issues?  Drive axle angle?
 Plenty of reasons.

Plus hacking up the hood a bit seems TONS easier.



-----Original Message-----
From: scirocco-l-bounces+dmaula=gordonrees.com@scirocco.org
[mailto:scirocco-l-bounces+dmaula=gordonrees.com@scirocco.org] On Behalf
Of Brett Van Sprewenburg
Sent: Tuesday, April 05, 2005 4:13 PM
To: Dan Bubb
Cc: scirocco-l@scirocco.org
Subject: Re: ABA swap into MK II Scirocco


>Hey everyone,
>
>Next project on the horizon is swapping a complete ABA w/cross flow
>head and the "over-the-top" manifold into an 86 Scirocco.
>
>The concern I have is clearance between the intake manifold and the 
>hood.
>
>I know somebody else has already done this swap.
>
>Anybody know who did it or know whether they had clearance issues or
>what they may have done to solve them??
>
>TIA
>Dan
>

You're the custom motormount king lately...why not cut and weld a set 
that lowers
the motor about 12mm?


==Brett

_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org http://neubayern.net/mailman/listinfo/scirocco-l 
 
 
--------------------------------------------------------

San Francisco  *  San Diego  *  Los Angeles  *  Sacramento  *  Orange County  *  Las Vegas  *  Portland  *  Houston  *  Phoenix  

This email communication may contain CONFIDENTIAL INFORMATION WHICH ALSO MAY BE LEGALLY PRIVILEGED and is intended only for the use of the intended recipients identified above. If you are not the intended recipient of this communication, you are hereby notified that any unauthorized review, use, dissemination, distribution, downloading, or copying of this communication is strictly prohibited. If you are not the intended recipient and have received this communication in error, please immediately notify us by reply email, delete the communication and destroy all copies. GORDON & REES LLP  http://www.gordonrees.com