[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

questions on removing fuel distro



The metal braided line from the dist back under the car is the return line 
to the tank. The fuel line runs to the back side of the fuel filter on the 
right side of the fuel dist.
Remove the line to the fuel filter and the one from the filter to the dist.

That should stop the leak.

Pull the injectors using a pair of vice grips, remove the lines to the FPR 
on the front of the engine and the one to the cold start and the whole mech 
will lift right out. Its easier to handle in one piece.

Having fun yet?

Julie Macfarlane
1981 MKI 2L 16v w 2Y
Amsterdam NY
http://www.menloparkrandd.com/scirocco
http://www.menloparkrandd.com/my_rocc





>From: Dan Smith <sad_rocc@yahoo.com>
>To: scirocco-l@scirocco.org
>Subject: questions on removing fuel distro
>Date: Tue, 4 May 2004 14:35:40 -0700 (PDT)
>
>While soaking various bits in PB Blaster I decided to start pulling the 
>fueling bits. I only broke 1 injector, which I think is pretty good and 
>disconnected all the lines. One line however refuses to stop leaking gas. 
>It's the one that connects onto the same bolt as another line on the fuel 
>distro and runs down and under the car. I figured there'd be some gas left 
>in the line so I got it into a jar and waited until it stopped dripping. I 
>figured it was all drained then. Well, today is around 80 and the heat 
>seems to have started a small fountain of gas spewing again. I've connected 
>the line to the fuel pump (filter maybe? the small grey cylinder in the 
>same area) and hopefully this will at least keep the fuel from dripping on 
>the ground. Aside from draining the tank, how do I stop this line from 
>flowing?
>
>Dan
>
>
>---------------------------------
>Do you Yahoo!?
>Win a $20,000 Career Makeover at Yahoo! HotJobs
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l