hot engine after-run circuit

[txrocco@sbcglobal.net (ATS - Patrick Bureau)]

hummm.... I have 2 85 CIS rocco, and I aint go no sensor between the
cylinder head cover and the intake manifold.
you have a picture of this ?

ATS - Patrick Bureau - txrocco@sbcglobal.net


=>-----Original Message-----
=>From: scirocco-l-admin@scirocco.org
=>[mailto:scirocco-l-admin@scirocco.org]On Behalf Of Drew MacPherson
=>Sent: Sunday, March 16, 2003 6:27 AM
=>To: Allyn
=>Cc: scirocco list
=>Subject: Re: hot engine after-run circuit
=>
=>
=>
=>The after-run circuits I have seen on 8V cars have a temperature sensor
=>mounted on a bracket in between the cylinder head cover and the intake
=>manifold.  The sensor is open to air - not in the water jacket.
=>
=>CIS cars use a 110C switch that's blue, digifant uses a 100C
=>switch that's
=>yellow, and TurboDiesels use a 115C switch that's white.  Corrados with
=>after-run use a 90C switch (blue again - thanks VW)
=>
=>I've been looking at available temperature switches to control my low
=>speed fan on the rad (to draw more air through the I/C) and possibly to
=>control an IC misting system as well, in case you were wondering why I
=>have all these temps and colours handy... :)
=>
=>
=>Does this help answer your question at all?  I haven't had a cup of
=>coffee yet, so I may have missed the mark... :)
=>
=>Drew
=>
=>On Sat, 15 Mar 2003, Allyn wrote:
=>
=>> when i put the 2.0 in the rieger i was left scratching my head when
=>> reconnecting one of the wires. on the right side of the head there are 4
=>> senders. the 2 bottom ones are easy (color coded plugs), the
=>upper rear is a
=>> tab that sticks out (also easy, since there is only one plastic covered
=>> connector for that as well). the upper front is a flat disc
=>thats meant to
=>> take a typical crimp connector type plug, only sideways. the
=>catch is that
=>> there is another one of these same flat discs at the rear right
=>side of the
=>> head, yet i have only one connector to put on. im fairly
=>certain the wire is
=>> to the after-run circuit, but the bentley gets really sketchy
=>when it talks
=>> about this circuit. i cant find the wire in the schematics, and
=>cant find a
=>> physical head-sensor layout in there either. has anyone figured out what
=>> goes where as far as these single wire connections go?
=>> Al
=>>
=>>
=>> _______________________________________________
=>> Scirocco-l mailing list
=>> Scirocco-l@scirocco.org
=>> http://neubayern.net/mailman/listinfo/scirocco-l
=>>
=>
=>--
=>/=============================================\
=>|  84 Wolfsburg Edition TurboDiesel Scirocco  |
=>|    http://scirocco.cs.uoguelph.ca/gtd       |
=>\=============================================/
=>
=>
=>_______________________________________________
=>Scirocco-l mailing list
=>Scirocco-l@scirocco.org
=>http://neubayern.net/mailman/listinfo/scirocco-l