How to pull the hub off the bearing?

[txrocco@sbcglobal.net (Patrick Bureau)]

hummm tobias last time bearings on my rocco's required
to be changed and I am assuming your talking about the
front ones, one required 18 tons of pressure, and the
other 12 tons to "pop" them out.. 
unless you change your bearings like every 3 months I
doubt very much that a bearing puller will be able to
produce this kind of ton/sq'in power.

who knows...

--- "Tobias ><" <scirocco16v88@hotmail.com> wrote:
> 
> I'm going to replace the wheel bearings myself, but
> I need to know if there 
> is a patented Cheapass method of pulling the Hub of
> the Bearing - or do I 
> need one of those fancy hub pullers?
> 
> I do not intend to remove the hub and bearing
> assembly from the car - I'm 
> going to change the bearing while the bearing
> housing is still attached. I'm 
> going to use a bearing puller installer tool for
> this.
> 
> Thanks,
> T
> 
>
_________________________________________________________________
> The new MSN 8: advanced junk mail protection and 2
> months FREE*  
> http://join.msn.com/?page=features/junkmail
> 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l