Speedo

[Joe.Doty@lcnetwork.com (Joe Doty)]

Nope.  First pull off all the plastic crap under the steering column
(two-piece tray, etc).  Then reach up and unclip the speedo cable off of
the gauge cluster.  Remove the black bezel in front of the cluster, it's
held in by two screws.  The most difficult part is unclipping the wire
harnesses from the cluster.  My favorite method, although it lends
itself to easier self-mutilation, was to use a large flathead
screwdriver to push and pry at the same time.  Once those are off, it's
a simple* matter of pulling the cluster out and around the steering
wheel.

*difficult

HTH.  Good luck.

Joe Doty
IT/Development
joe@lcnetwork.com=20

-----Original Message-----
From: Scirocco16vJay@aol.com [mailto:Scirocco16vJay@aol.com]=20
Sent: Tuesday, April 15, 2003 3:41 PM
To: scirocco-l@scirocco.org
Subject: Speedo

Do I need to take the whole dash off to install a new speedo on a mk2
rocco?

Jason Frasca aka "Rocco"
1988 Scirocco 16v