[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
swap solid head internals to hydrolic head
- Subject: swap solid head internals to hydrolic head
- From: alienj@bad-candy.com (fryer)
- Date: Fri, 7 Jun 2002 06:10:11 -0400
>Say, what's wrong with the JH head on your 85? It would fit on
top of any 8v
>1.8l bottom end. Unless it's warped beyone repair, or cracked, or
has broken
>Ezout in broken exhaust stud, or the cam bearings are roasted,
then it
>should be just fine. The JH head is very nice. Keep it if
possible.
>
>HTH,
>Jonas
apparently at some point foreign debris entered the 1,2,3
cylinders and the pistons as well as the quench area of the head
have severe pitting (.050"+) as soon as i can im going to to go a
machine shop, have them measure it to see if it is already at
minimum deck height, if not, i'll see how much they can machine it
down, but people who have seen the head are not enthusiastic about
any repair.
chris fryer
________________________________________________________________
Get your own evilemail.com address at http://www.evilemail.com