Flange cap seals

[foxxinabox@copper.net (Foxx (in a box))]

> I replaced both flange seals on the FN tranny. the outer big ones. I
> also replaced both the caps/seals that reside inside the flanges. But
> the one on the drivers side had a hole in it,it was machined on the
> joint side . My mechanic had replaced that cap 20K miles ago. Is it
> possible he put the wrong one? I thought there was only "one size fits
> all",
> What would cause that to happen ? improper installation?

  most likely. that can happen when the seal is tapped in too far. not a
whole lot of clearance there. my problem ended up being that the
bearings were shot (in my 4k). 

-- 
 /\_/\	  Foxx (in a box)
< o o >	  http://foxx.tripod.com
  \ /
   °