[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Badger 5 t-bodies

To: "Cheapass Ron" <rapieper@yahoo.com>
Subject: RE: Badger 5 t-bodies
From: "Scott F. Williams" <sfwilliams@home.com>
Date: Wed, 5 Sep 2001 20:53:48 -0400
Cc: "Lauri Pettai" <lauri.pettai@netexpress.ee>,<scirocco-l@scirocco.org>
Importance: Normal
In-Reply-To: <20010905190014.98378.qmail@web10308.mail.yahoo.com>
Sender: owner-scirocco-l@scirocco.org
-over the tranny... Yeah, that would be much better than over the engine
itself. It'd still look messy, though and then there's the redirection of
the air problem. The fender well might work but then that isn't a
high-pressure area. And it still requires a fairly intensive plumbing build
verses just pulling the cold air in from directly in front of the grill like
God intended. There is no better place to bring it in!

Mind you, neither of your two ideas are bad in my opinion. Thanks much for
the ideas, too. You've got me thinkin' here. (Uh oh! Danger!)

:^)
--
Scott F. Williams
NJ Scirocco nut
Golf GTI 16v rallycar
Mazda 323 GTX turbo assault vehicle

Check out our rally team's website!
http://www.usrallyteam.com

> -----Original Message-----
> From: owner-scirocco-l@scirocco.org
> [mailto:owner-scirocco-l@scirocco.org]On Behalf Of Cheapass Ron
> Sent: Wednesday, September 05, 2001 3:00 PM
> To: Scott F. Williams; Cheapass Ron; Lauri Pettai
> Cc: scirocco-l@scirocco.org
> Subject: RE: Badger 5 t-bodies
>
>
> Well, it'd be over the tranny, but farther removed than the factory
> piece is.
>
> My other brainstorm is something behind the front fenderwell...
>
> Ron
>
>
> --- "Scott F. Williams" <sfwilliams@home.com> wrote:
> > Ya, but running the duct from the fresh air area would necessitate
> > running a
> > duct over the hot engine. I fear that it would get heat soaked and
> > negate
> > the gains. It would also add a goofy-looking apparatus cluttering up
> > the
> > engine bay. -not at all important from a racing point of view, but
> > not quite
> > what this guy is looking for on the street.
> >
> > My two ideas are to install a shorter/wider radiator (i.e. compared
> > to my 8v
> > rad. Roughly 16v width but 2" shorter...), or to section the radiator
> > support to move the stock unit down the same distance. I'm not sure
> > which is
> > more work but I'd probably go with the custom rad setup...
> >
> > Hmmm...
> > ______________________________
> > Scott F. Williams
> > Account Manager
> > GENUiTY - Eastern Region
> > 100 Wall Street, 10th Floor
> > New York, NY 10005
> > Voice: 212.416.1745
> > Cell: 917.648.2256
> > Fax: 212.618.5160
> > scott.williams@genuity.com
> >
> > > -----Original Message-----
> > > From: owner-scirocco-l@scirocco.org
> > > [mailto:owner-scirocco-l@scirocco.org]On Behalf Of Cheapass Ron
> > > Sent: Wednesday, September 05, 2001 11:24 AM
> > > To: Lauri Pettai; Scott F. Williams
> > > Cc: scirocco-l@scirocco.org
> > > Subject: RE: Badger 5 t-bodies
> > >
> > >
> > > Has anyone investigated obtaining cold intake air from the fresh
> > air
> > > area (by the firewall)?  The intake from the airbox would be ducted
> > > back to the "tray", a port would be added easily enough, water
> > drainage
> > > is already done...if one would want to add some external ducting,
> > it
> > > could be in the form of a little scoop over the existing vents in
> > the
> > > hood...
> > >
> > > Worth considering?
> > >
> > > Ron
> > > --- Lauri Pettai <lauri.pettai@netexpress.ee> wrote:
> > > > I've been wondering, is there a possibility to rebuild the
> > > > front end of the Scirocco so that you can unscrew it if you
> > > > like? Like you can do it with golfs. Then I'd do it so that
> > > > I'd put the radiator a bit lower to make the room for the
> > > > cool air intake. Lot of custom building, but it might be
> > > > worth it?
> > > >
> > > > Hood scoop thingie is not going to work as the place where
> > > > you'd have to put the scoop has actually vacuum in there.
> > > > So no air is going to go in from there. Only out.
> > > >
> > > > Lauri!
> > > > '84 2.0 16v Scirocco GTX Kamei X1 Bodykit (VIN025736)
> > > > http://www.eabc.edu.ee/~laurts/scirocco
> > > > I finally added something new to my site!
> > > >
> > > >
> > > > > -----Original Message-----
> > > > > From: owner-scirocco-l@scirocco.org
> > > > > [mailto:owner-scirocco-l@scirocco.org]On Behalf Of Scott F.
> > > > Williams
> > > > > Sent: 04. september 2001. a. 22:54
> > > > > To: Lauri Pettai
> > > > > Cc: scirocco-l@scirocco.org
> > > > > Subject: RE: Badger 5 t-bodies
> > > > >
> > > > >
> > > > > As some may know, I have considered and researched these
> > throttle
> > > > bodies for
> > > > > my own car. I absolutely do not want install a scoop in my
> > hood.
> > > > So, I'm
> > > > > looking into costs for a custom-built rad that is shorter and
> > wider
> > > > -thus
> > > > > allowing cool air to flow in through the grill. Or, perhaps
> > there
> > > > is a stock
> > > > > fitment for another car that'll do the trick. I'll follow up
> > with
> > > > some
> > > > > details later.
> > > > > ______________________________
> > > > > Scott F. Williams
> > > > > Account Manager
> > > > > GENUiTY - Eastern Region
> > > > > 100 Wall Street, 10th Floor
> > > > > New York, NY 10005
> > > > > Voice: 212.416.1745
> > > > > Cell: 917.648.2256
> > > > > Fax: 212.618.5160
> > > > > scott.williams@genuity.com
> > > > >
> > > > > > -----Original Message-----
> > > > > > From: owner-scirocco-l@scirocco.org
> > > > > > [mailto:owner-scirocco-l@scirocco.org]On Behalf Of T Berk
> > > > > > Sent: Tuesday, September 04, 2001 4:29 PM
> > > > > > To: Lauri Pettai
> > > > > > Cc: Victor Farren; scirocco-l@scirocco.org
> > > > > > Subject: Re: Badger 5 t-bodies
> > > > > >
> > > > > >
> > > > > > Lauri Pettai wrote:
> > > > > > >
> > > > > > > Ok the manufacturer of the TB's went the easy way and
> > drilled a
> > > > > > hole to the
> > > > > > > 4th runner and tapped the vacuum line there and that's it.
> > I'm
> > > > > > a bit afraid
> > > > > > > to do
> > > > > > > this as it would make the cyl's to work uneqally and on
> > racing
> > > > > > conditions
> > > > > > > with lot of sudden and strong breaking etc. it could melt
> > your
> > > > > > pistons. :(
> > > > > > > I already worr about my engine as two cylinders get the hot
> > air
> > > > > > trough the
> > > > > > > radiator and two cylinders get the cool air directly from
> > > > > > grill. And already
> > > > > > > that's
> > > > > > > not good. So lots of work to do still. I'm wondering is
> > there
> > > > > > any radiators
> > > > > > > that
> > > > > > > are long and not very high so that I could use the upper
> > part
> > > > > > of the grill
> > > > > > > to
> > > > > > > feed cool air to throttlebodies and lower to cool the
> > water?
> > > > > > >
> > > > > >
> > > > > >
> > > > > > The 1st thing I thought was a hood scoop to feed cool outside
> > > > air. Put a
> > > > > > screen across it to keep large chunks out and away you go.
> > > > > >
> > > > > > Looks cool with those trumpets on there; one of the things I
> > > > don't like
> > > > > > about the cross flow motors is the intake runners across the
> > top
> > > > of the
> > > > > > head. Makes later model engines too tall for Sciroccos.
> > > > > >
> > > > > > TBerk
> > > > > >
> > > > > > --
> > > > > > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > > > > > To unsubscibe send "unsubscribe scirocco-l" in the message to
> > > > > > majordomo@scirocco.org
> > > > > >
> > > > >
> > > > >
> > > > > --
> > > > > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > > > > To unsubscibe send "unsubscribe scirocco-l" in the message to
> > > > majordomo@scirocco.org
> > > >
> > > > --
> > > > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > > > To unsubscibe send "unsubscribe scirocco-l" in the message to
> > > > majordomo@scirocco.org
> > > >
> > >
> > >
> > > =====
> > > Ron (Cheapass)
> > > '87 16V, ("Victor"), '93 Cabby ("Teufelhasen")
> > > ICQ 108845455
> > >
> > > Stupid is as stupid does.
> > > -F. Gump
> > >
> > > __________________________________________________
> > > Do You Yahoo!?
> > > Get email alerts & NEW webcam video instant messaging with Yahoo!
> > > Messenger
> > > http://im.yahoo.com
> > >
> > > --
> > > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > > To unsubscibe send "unsubscribe scirocco-l" in the message to
> > > majordomo@scirocco.org
> > >
> >
> === message truncated ===
>
>
> __________________________________________________
> Do You Yahoo!?
> Get email alerts & NEW webcam video instant messaging with Yahoo!
> Messenger
> http://im.yahoo.com
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
> majordomo@scirocco.org
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
Follow-Ups:
- Re: Badger 5 t-bodies
  - From: "Casey Webster" <tinfool@home.com>
- RE: Badger 5 t-bodies
  - From: Riley McDowall <roog@telus.net>
References:
- RE: Badger 5 t-bodies
  - From: Cheapass Ron <rapieper@yahoo.com>
Prev by Date: RE: brake booster vacuum?
Next by Date: RE: Badger 5 t-bodies
Prev by thread: RE: Badger 5 t-bodies
Next by thread: Re: Badger 5 t-bodies
Index(es):
- Date
- Thread