Re: flange puller tool

[Cheapass Ron <rapieper@yahoo.com>]

M10-1.5, I'm pretty sure.

Nice going on kicking honda butt.

Ron

--- the mad bastard <the-mad-bastard@home.com> wrote:
> 
>     hey people, i kinda demoed my latest
> tranny/clutch setup after feeding a
> MK4 VR golf, a yellow typeR, and a couple of civics
> their asses on the
> highway on saturday night.
> 
>     it appears that i blew out one of the inner
> seals that holds oil inside
> the tranny.  no biggie, really.  the tranny was put
> in after i blew up my
> previous one at the bug show last year.  i knew that
> it was temporary.
> 
>     i've picked up a 4K to replace the wounded 9A
> from drew macpherson (you
> da man, drew).  also, i've ordered a new clutch,
> both inner tranny seals
> (the ones that go around the clutch release shaft),
> and new axle flange
> kits.
> 
>     the 4K flanges are 90mm, but i want to use my 9A
> 100mm flanges.
> however, i don't have an axle flange removal tool,
> so i wish to make one up.
> can anyone tell me what the thread pitch is inside
> of the flange that will
> allow me to get these things off with a minimum f
> time/effort?  thanks!
> 
> jason
> the mad bastard
> 
> 
> --
> Email LIST problems to:
> scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the
> message to majordomo@scirocco.org
> 


__________________________________________________
Do You Yahoo!?
Yahoo! Auctions - buy the things you want at great prices
http://auctions.yahoo.com/

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org