[ELEC]- Anti-knock set up in hand, now what?

[Cmr446@cs.com]

  After finding the only remaining complete anti-knock setup in an Audi 4K, 
the knock box (smaller of two black boxes w/ vac line, right?), distr., 
sensor, ign. module, and all the wiring connecting it all together from the 
engine bay to the boxes, I have a few questions.
  Will I need the other ECM, the larger of the two black boxes for this to 
run right? Do I need ALL the sensor leads for this (water temp, CIS-E 
hook-ups, air bypass control) or can I run this seperate of the engine's 
electronics (alt, temp sensors, fuel regulator, on one side; AK box, distr., 
throt. switches, knock sens., and coil, on other side)? 
  Plan on installing into the 77 rocco. May go into Fox depending on what I 
find out for that. 

Thanks!
Carl
77rocco (you want to put what? where??)
89fox

  

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org