Re: chassis stiffening: Here's a link of 1st hand experience

[Jean-Claude Desinor <desinor@sympatico.ca>]

  Have a look for yourself:

  <http://www.por15.com/>

	Jean-Claude
	84 8v

Allyn a écrit :
> 
> whats this por15 stuff?
> is it clear, colored? shiny, dull?
> where do we get it, and how good it is?
> al
> 
> Allyn Malventano, ET1(SS), USN
> 87 rocco 16v (rieger gto - green - 'der rocco' - restoration complete)
> 87 jetta 8v wolfsburg 2dr (260k, still tight :)
> 
> ----- Original Message -----
> From: "Gary Huff" <scirocco86@home.com>
> To: "Scott Williams" <scwillia@genuity.com>
> Cc: <scirocco-l@scirocco.org>
> Sent: Monday, July 02, 2001 11:22 AM
> Subject: Re: chassis stiffening: Here's a link of 1st hand experience
> 
> > How about coming up with ways to seal the metal so that moisture can not break through? I'd say
> it's worth it since the A1 chassis needs any amount of re-enforcement/stiffness it can get. Aside
> from por-15(the only thing I can think off...)are there any ways of sealing the metal/paint? BTW, by
> purchasing a spray wand from eastwood(body/paint supply comp.) and with an air compresor & patience
> you could get por-15 inside of the rockers... this is what im doing to my 75 so it doesn't rot from
> the inside out in a few years....... I think the gain is worth the cost, and rust prevention inside
> of the rockers isn't necessarily a bad thing on these cars -- the 80 parts car in my driveway sure
> could have used it, the rockers are turning into peanut brittle :) What do you all think? Peace,
> > -Gary Huff
> >
> > On Mon, Jul 02, 2001 at 09:39:15AM -0400, Scott Williams wrote:
> > > Yeah, what I'm hearing is that the stuff really works to stiffen the
> > > chassis. However, the stories about it promoting rust are too prevalent to
> > > ignore. I wonder if there are any spots in the A1 chassis that are not so
> > > rust prone. -but would these spots offer any stiffening is another question.
> > >
> > > Damn.
> > >
> > > > -----Original Message-----
> > > > From: Craig Williams [mailto:roccolister@hotmail.com]
> > > > Sent: Saturday, June 30, 2001 1:50 PM
> > > > To: Scott Williams; Scirocco List
> > > > Subject: Was: chassis stiffening: Here's a link of 1st hand experience
> > > >
> > > >
> > > > Hey all,
> > > >
> > > > Here's a link to a site of a guy that I know who did this with his RX-7 a
> > > > couple of years ago. Check it out...
> > > >
> > > > http://www.geocities.com/dorifto/urethane.html
> > > >
> > > > -- --Craig Williams
> > > > 1981 Scirocco S 2008cc 16V (As seen in 01-2001 Sport Compact Car)
> > > > 1991 Passat Wagon 2.0 16V (For the Wife & baby)
> > > > 2000 Saab Viggen (20 psi, Turbo charged monster)
> > > > Northern California, USA
> > > ______________________________
> > > Scott F. Williams
> > > Account Manager
> > > GENUiTY - Eastern Region
> > > 100 Wall Street, 10th Floor
> > > New York, NY 10005
> > > Voice: 212.416.1745
> > > Cell: 917.648.2256
> > > Fax: 212.618.5160
> > > scott.williams@genuity.com
> > >
> > >
> > > --
> > > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > > To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> > >
> >
> > --
> > Email LIST problems to: scirocco-l-probs@scirocco.org.
> > To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> >
> >
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org