RE: Flames from exhaust....HOW TO -> scirocco.org

["Lauri Pettai" <lauri.pettai@netexpress.ee>]

Somebody please put this up on scirocco.org
tech procedures. :)


> Ok, well Im juvenile, and I cannot resist any longer, lemme tell ya how to
> do it !
>
> 1) Gather Supplies :
>      Windshield Squirter Module (Generic WalMart $12 (In the windshield
>       washer fluid isle))
>       CIS Injector or homemade variant ($5 Junkyard special)
>       SOLID STATE (electronic) Grill Igniter (Home Depot $14)
>       3/8" drill bit
>       Sheet Metal screw (Length varies)
>       High-temp Silicone Sealant
> Ok, here's what to do
>  1)  Drill hole approx 1" from back of muffler in the tailpipe,
> fit injector
>       seal with silicone.
> 2)  Approx 3-4" rearward, drill hole for the insulated igniter
> prong, fit in
> approx
>      1/4 way in, seal again.
> 3) 180 Degrees from the insulated prong, screw in the sheetmetal screw,
> leaving
>     a 1/2" gap between the two tips
> 4) connect the wires to the the electronics package (may have to lengthen
> wires to get the big red button in the passenger
> compartment)..Test to make
> sure you have a spark.
> 5) Run power to the back where the 'fuel pump' is to be located...wire up
> pump via switch.
> 6) Run line from a gas can to the pump, then to the fuel injector
> 7) Engine may have to be above 1800RPM or so...actually, I would highly
> recommend it !
> 8) FIRE
>
> ***Notice, I am writing this SOLELY for EDUCATIONAL purposes, I am not
> responsible for damage/loss of exhaust system, car, body parts, small
> singed, previously furry house pets, etc.....*****
>
>
> -Steve H
>   '88 16v Rocco
>
>
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org