[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Flames from exhaust....HOW TO
Ok, well Im juvenile, and I cannot resist any longer, lemme tell ya how to
do it !
1) Gather Supplies :
Windshield Squirter Module (Generic WalMart $12 (In the windshield
washer fluid isle))
CIS Injector or homemade variant ($5 Junkyard special)
SOLID STATE (electronic) Grill Igniter (Home Depot $14)
3/8" drill bit
Sheet Metal screw (Length varies)
High-temp Silicone Sealant
Ok, here's what to do
1) Drill hole approx 1" from back of muffler in the tailpipe, fit injector
seal with silicone.
2) Approx 3-4" rearward, drill hole for the insulated igniter prong, fit in
approx
1/4 way in, seal again.
3) 180 Degrees from the insulated prong, screw in the sheetmetal screw,
leaving
a 1/2" gap between the two tips
4) connect the wires to the the electronics package (may have to lengthen
wires to get the big red button in the passenger compartment)..Test to make
sure you have a spark.
5) Run power to the back where the 'fuel pump' is to be located...wire up
pump via switch.
6) Run line from a gas can to the pump, then to the fuel injector
7) Engine may have to be above 1800RPM or so...actually, I would highly
recommend it !
8) FIRE
***Notice, I am writing this SOLELY for EDUCATIONAL purposes, I am not
responsible for damage/loss of exhaust system, car, body parts, small
singed, previously furry house pets, etc.....*****
-Steve H
'88 16v Rocco
--
Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org