Re: side moulding removal

["Ryan Schuermann" <rts@nol.net>]

what holes?
my rocco was smooth, pur peeled it off during a sunny warm day then
got a flat plastic piece like a spatchula and scraped the rest off 
gently then used goo-gone on the res then waxed. did this to my 
Scirocco and Corrado w/ no problems.

Ryan
> 
> nope, except for the holes,
> it is smooth and follows the body line.
> 
> 
> Alex Ting
> Millennium Solutions Group, Inc.
> 8303 Sierra College Blvd., Suite 150
> Granite Bay, CA 95746
> 
> Phone: 888-801-2001 or 916-797-9998
> Fax: 916-797-9997
> Email: alex@millenniumsolutions.net
> 
> 
> 
> ----------
> > From: Cory Fonger <phantom9e@yahoo.com>
> > To: scirocco list <scirocco-L@scirocco.org>
> > Subject: Re: side moulding removal
> > Date: Monday, November 09, 1998 11:56 AM
> > 
> > one question for those of you who have done this: is there an indent
> > underneath the moulding?
> > 
> > 
> > 
> > 
> > ---Owen <rabeys@cadvision.com> wrote:
> > 
> > > I havn't done this yet, but plan to in the future.  I remember the
> > best way
> > > was to use heat to let the adhesive get tacky, then you can just
> > pull it
> > > off as you pry the glue with an impliment (i remember mention of sore
> > > fingernails, and plastic spoons or something), then once all the
> > rubber is
> > > off, use some type of adhesive remover.  i remember talk of 3M
> > Adhesive
> > > remover being the best. 
> > > 
> > > 	good luck
> > 
> > ==
> > 
> > elf
> > _________________________________________________________
> > DO YOU YAHOO!?
> > Get your free @yahoo.com address at http://mail.yahoo.com
> > 
> > 
> > --
> > To subscribe or unsubscribe, send email to
> scirocco-L-request@scirocco.org,
> > with your request (subscribe, unsubscribe) in the BODY of the message.
> 
> --
> To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
> with your request (subscribe, unsubscribe) in the BODY of the message.
> 
> 

--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.