Re: side moulding removal

["Owen" <rabeys@cadvision.com>]

Holes??  Are we talking about the same molding?  I think he was asking
about the rubber strips that run along the side of the car.  Not a body
kit.  Can the original poster clarify?

	
Owen
87 16v
http://www.geocities.com/MotorCity/Garage/1571

> nope, except for the holes,
> it is smooth and follows the body line.
> 
> 
> Alex Ting
> > one question for those of you who have done this: is there an indent
> > underneath the moulding?


> > ---Owen <rabeys@cadvision.com> wrote:
> > 
> > > I havn't done this yet, but plan to in the future.  I remember the
> > best way
> > > was to use heat to let the adhesive get tacky, then you can just
> > pull it
> > > off as you pry the glue with an impliment (i remember mention of sore
> > > fingernails, and plastic spoons or something), then once all the
> > rubber is
> > > off, use some type of adhesive remover.  i remember talk of 3M
> > Adhesive
> > > remover being the best. 
> > > 
> > > 	good luck
>

--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.