[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: 1.9L G60 engine
To get a 1.9L G60 you will need "overbore" 83.5mm Forged Pistons for
turbo/supercharged motors.
These are available through VELOCITY (Phone # 310-643-0005) and are made in
the USA by the world famous JE. 83.5mm Pistons with the stock stroke of
86.4mm yeild a sweapt volume of 1892.5cc or 1.8925Litres ( ~1.9L). You may
also use the 82.5mm piston for a displacement of 1847.4 cc or ~1.85Litres.
Use the stock compression ratio. However, if you are not going to use a
smaller G-ladder pulley you may bump the compression to 8.75 or 9:1 for an
increase in low rpm torque. If you use a smaller pulley with the higher
compression pistons you will surely destroy the motor from detonation.
***************************************************************
Brian M. Gracek Saint Cloud, MN USA
Student of Chemistry St. Cloud State University
Student Member of the ACS Proud member of the MNANG
VW ... Drivers Wanted
***************************************************************
Brian M. Gracek Saint Cloud, MN USA
Student of Chemistry St. Cloud State University
Student Member of the ACS Proud member of the MNANG
VW ... Drivers Wanted
--
To subscribe or unsubscribe, send email to scirocco-l-request@privateI.com,
with your request (subscribe, unsubscribe) in the BODY of the message.