[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Timing the cam - Great answers!
Thanks to Jim, Karl and Dan for your excellant advice.
I did not know about the dist. mark so will check that out.
I will relocate the dist as needed for play and ensure that #1 is in
the
right position.
Seeing as I have had the pulleys/timing cover off 2x now (I did change
the belt)
I will focus on the dist.
Thanks for your explanation re: the timing marks.
Great education for me!
Cheers
Ed '81S
>>> "Jim R" <sciroccos@earthlink.net> 1/18/2007 11:06 AM >>>
You should never have to "rewire" the cap. There's a mark on the edge
of
the distributor that indicates where the #1 wire/cap position should
be.
Set up your cap so that the #1 wire is there, then install the
distributor
(with the engine at TDC) so the rotor is pointing to this mark (very
important).
You can make sure you position the distributor so that there's enough
room
to adjust it in either direction. (hint: you can reposition the tang
in the
dist hole if needed; it's just a drive for the oil pump and has nothing
to
do with the timing.
Jim
>-----Original Message-----
>From: Edward Effinger [mailto:Eeffinger@conestogac.on.ca]
>Sent: Thursday, January 18, 2007 10:46 AM
>To: verboten1@gmail.com; Karl Krupke
>Cc: scirocco-l@scirocco.org
>Subject: Re: Timing the cam - what about the intermediate shaft
>tocrankshaft?
>
>
>Hi Karl and Jim.
>Thanks for your replies.
>I'm still not clear on the intermediate timing mark need.
>Here's what I have done.
>
>- Located tdc using the mark on the flywheel
>- adjusted the cam shaft sprocket mark to the cylinder head as per
>manual
>- adjusted the intermediate shaft to match the crankshaft
>- rewired the dist cap to ensure #1 was aligned (it was out by 90deg
as
>a result of timing the shaft)
>- it started ok, but the dist was on full retard in order to get it
to
>run
>- I then advanced the intermediate shaft in order to advance the dist
>rotation in order to have more
> play in the dist movement. This caused me to rewire the cap by
>another 90 deg).
>- I think I could also just remove the dist, turn the oil pump drive
>slot and reinsert the dist.
>
>Conclusion.
>Still don't know why the intermediate shaft has an alignment mark, as
>it seems the position could be
>anywhere, so long as you line up the dist to fire at #1.
>
>I welcome any enlightening info.
>Cheers
>Ed '81S
>