[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Manifold tubes are plastic?!?

Not in this case. There both plastic as is apparent in the photos on 
www.worldimpex.com


From: "Sean Whalen" <hareless@gmail.com>
To: "Allyn" <amalventano1@tds.net>; <scirocco-l@scirocco.org>
Sent: Sunday, April 15, 2007 8:32 PM
Subject: Re: Manifold tubes are plastic?!?


> Since I have a whopping 256MB I don't have ETKA, but could the difference 
> in
> the numbers be plastic vs. brass?
> On 4/15/07, Allyn <amalventano1@tds.net> wrote:
>>
>> > ETKA is a little difficult to understand here, but the part
>> > number is either
>> > 063 133 555 or 063 133 555A.
>>
>> Generally, equal part numbers with letters added indicate the same part 
>> at
>> a newer revision.
>> Chances are both of those are equal, with the "A" part simply being a
>> revised design.
>> HTH
>> Al
>>
>>
>> _______________________________________________
>> Scirocco-l mailing list
>> Scirocco-l@scirocco.org
>> http://neubayern.net/mailman/listinfo/scirocco-l
>>
>
>
>
> -- 
> Sean
> A-1 x 2
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>