Manifold tubes are plastic?!?

[julie at menloparkrandd.com (julie@menloparkrandd.com)]

IIRC brass expands & contracts more than the plastic. Not a good thing when you need a good pressure seal.

>-----Original Message-----
>From: Sean Whalen [mailto:hareless@gmail.com]
>Sent: Sunday, April 15, 2007 08:32 PM
>To: 'Allyn', scirocco-l@scirocco.org
>Subject: Re: Manifold tubes are plastic?!?
>
>Since I have a whopping 256MB I don't have ETKA, but could the difference in
>the numbers be plastic vs. brass?
>On 4/15/07, Allyn <amalventano1@tds.net> wrote:
>>
>> > ETKA is a little difficult to understand here, but the part
>> > number is either
>> > 063 133 555 or 063 133 555A.
>>
>> Generally, equal part numbers with letters added indicate the same part at
>> a newer revision.
>> Chances are both of those are equal, with the "A" part simply being a
>> revised design.
>> HTH
>> Al
>>
>>
>> _______________________________________________
>> Scirocco-l mailing list
>> Scirocco-l@scirocco.org
>> http://neubayern.net/mailman/listinfo/scirocco-l
>>
>
>
>
>-- 
>Sean
>A-1 x 2
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>