who's done a power window swap in MK2?

[jlagnese at massed.net (John Lagnese)]

I had decent panels from the donor.

-----Original Message-----
From: Lance LaPrarie [mailto:sciroccojunky@gmail.com] 
Sent: Friday, April 06, 2007 1:31 PM
To: Roger
Cc: Scirocco list
Subject: Re: who's done a power window swap in MK2?

what did you use to cut the switch holes in the door cards? I was
thinking a
cutoff wheel on my dremel. I have a set of door panels off the doner car
but
they are all leather and kind of beat. However, they have the correct
holes.
I was going to put tape on my manual ones and mark them with a sharpie.




On 4/6/07, Roger <rogercv1@gmail.com> wrote:
>
> I plugged it in, I also had the full harness. did not want to splice
> either.
>
> On 4/6/07, Lance LaPrarie <sciroccojunky@gmail.com> wrote:
> > I would prefer to totally keep this harness intact where I don't
have to
> > splice in or anything. The car I pulled it from was fully
functional. I
> > pulled it and forgot where the two wires went. Also, there are a few
> options
> > as far as voltage goes on the back of the fuse panel. I didn't want
to
> just
> > plug it in anywhere and risk a fire or short, etc......
> >
> > Did you just plug yours in or did you splice it? I'd think that just
> > plugging it in would work since I didn't have to cut anything when I
> took
> > them off the donor car.
> >
> >
> > On 4/6/07, Roger <rogercv1@gmail.com> wrote:
> > > Ididi this swap a while back. I found a black and yellow plug on
the
> > > back of the fuse box loose and plugged the window harness to that.
the
> > > Battery I just followed the main battery cable to the fuse box and
> > > used the open connections on the back of the fuse box next to the
> > > battery cable.
> > >
> > > On 4/6/07, Lance LaPrarie < sciroccojunky@gmail.com> wrote:
> > > > I've got the switched black and yellow wire and the red power
wire.
> > After
> > > > looking at the bentley for a couple hours last night I couldn't
> figure
> > out
> > > > where on the back of the fuse panel they go. Anyone know of
where
> the
> > > > switched ignition wire goes and the appropriate power port are?
It
> would
> > > > have been nice if they would have had a pic of the back with all
the
> > numbers
> > > > and such to go off of. I need to get these in tonight since
tomorrow
> is
> > the
> > > > DCI bbq.
> > > >
> > > > Hook a brother up!!!
> > > > _______________________________________________
> > > > Scirocco-l mailing list
> > > > Scirocco-l@scirocco.org
> > > > http://neubayern.net/mailman/listinfo/scirocco-l
> > > >
> > >
> >
> >
>
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l