who's done a power window swap in MK2?

[rogercv1 at gmail.com (Roger)]

I plugged it in, I also had the full harness. did not want to splice either.

On 4/6/07, Lance LaPrarie <sciroccojunky@gmail.com> wrote:
> I would prefer to totally keep this harness intact where I don't have to
> splice in or anything. The car I pulled it from was fully functional. I
> pulled it and forgot where the two wires went. Also, there are a few options
> as far as voltage goes on the back of the fuse panel. I didn't want to just
> plug it in anywhere and risk a fire or short, etc......
>
> Did you just plug yours in or did you splice it? I'd think that just
> plugging it in would work since I didn't have to cut anything when I took
> them off the donor car.
>
>
> On 4/6/07, Roger <rogercv1@gmail.com> wrote:
> > Ididi this swap a while back. I found a black and yellow plug on the
> > back of the fuse box loose and plugged the window harness to that. the
> > Battery I just followed the main battery cable to the fuse box and
> > used the open connections on the back of the fuse box next to the
> > battery cable.
> >
> > On 4/6/07, Lance LaPrarie < sciroccojunky@gmail.com> wrote:
> > > I've got the switched black and yellow wire and the red power wire.
> After
> > > looking at the bentley for a couple hours last night I couldn't figure
> out
> > > where on the back of the fuse panel they go. Anyone know of where the
> > > switched ignition wire goes and the appropriate power port are? It would
> > > have been nice if they would have had a pic of the back with all the
> numbers
> > > and such to go off of. I need to get these in tonight since tomorrow is
> the
> > > DCI bbq.
> > >
> > > Hook a brother up!!!
> > > _______________________________________________
> > > Scirocco-l mailing list
> > > Scirocco-l@scirocco.org
> > > http://neubayern.net/mailman/listinfo/scirocco-l
> > >
> >
>
>