Which Loctite? (also: I HATE losing tools...)

[amalventano1 at tds.net (Allyn)]

The non-dried-out-normally-shaped o-ring IS the loctite for this item.
HTH
Al 

> -----Original Message-----
> From: Jeff Toomasson [mailto:area53@validpath.com] 
> Sent: Tuesday, September 12, 2006 11:14 AM
> To: Scirocco-l@scirocco.org
> Subject: Which Loctite? (also: I HATE losing tools...)
> 
> I'm still fuming about losing my 7mm idle adjuster wrench 
> this weekend. Saw it Saturday when I first started working on 
> the mk1, picked it up and put it somewhere and then couldn't 
> find it Sunday (HUGE bang-head icon...) I wasted my whole 
> 2-hour kid-free allotment looking for the f*cking 
> thing...didn't get $hit done...
> 
> Anyway, because I'm using a Fox intake on an ABA block, 
> adjustment of the idle screw is a PITA. To make it easier, i 
> took the angle grinder to the stalk where the adjuster screw 
> sits. Well, of course I took a little too much off, but not 
> too much to get a good ~1000rpm idle when adjusted properly. 
> Unfortunately though, after cleaning the screw's threads, the 
> screw keeps backing out which brings me to my main ? - which 
> Loctite should I use to get the screw to not back out but 
> still maintain a modicum of adjustability without ruining the 
> Loctite's "grab"?
> 
> Thanks!
> 
> JT
> 
> 
> 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l