The official not at Cincy thread

[koabi at seeohdee.com (Koabi Brooks)]

Got the laptop talking to the ECU now...

And finally got the freeze plug out and the crank position sensor in its
place (ABA block).

I have to find a power source for the coilpack and I think that's
it...getting scared now!

-----Original Message-----
From: darren24@mango.spoonohost.com [mailto:darren24@mango.spoonohost.com]
On Behalf Of Koabi Brooks
Sent: Saturday, June 03, 2006 9:38 PM
To: 'matt'; 'Gordy Stedman'; 'Todd Guse'; Scirocco-l@scirocco.org
Subject: RE: The official not at Cincy thread

So I made some progress today on the wiring harness.  The power supplies are
connected with exception of the coilpack.  I am trying to find out which pin
powers the old coil so I can steal that (I think pin 15 is power and pin 1
is tach signal...)

Tomorrow I will get all the grounds grounded and it will be try 2 to hook up
the 9 pin serial connection so I can interface with a laptop.  I fried a pin
trying to solder the comm wires onto the serial connector :x

Maybe I am close to cranking this...