[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
MS diagram?
Well Jeeze. Even Josh could do that.
I had to climb a mountain, up hill, both ways, in the snow, with out...
hey, you get the idea :)
(good link)
>-----Original Message-----
>From: Mtl-Marc [mailto:marc_scirocco@sympatico.ca]
>Sent: Tuesday, July 25, 2006 02:18 PM
>To: ''Brian Spinney'', ''Org, Scirocco''
>Subject: RE: MS diagram?
>
>Thanks for the info, this is what I am looking for.
>
>I found it on their web site. <<http://tinyurl.com/jyp35>>
>
>Not that expensive if you figure that you have no leg work to do. Its all
>there.
>
>Thanks again.
>
>Marc
>
>
>>
>> 034 efi sells a 16v trigger wheels setup. All that would be
>> needed is the 16v crank pulley and bigger lower timing belt
>> gear. It will run you $200 though.
>> -Brian
>>
>> 85 Scirocco 8vT 01 Jetta 20vT 84 Rabbit GTI
>>
>> ----- Original Message -----
>> From: "Mtl-Marc" <marc_scirocco@sympatico.ca>
>> To: "'Org, Scirocco'" <scirocco-l@scirocco.org>
>> Sent: Saturday, July 22, 2006 1:08 PM
>> Subject: RE: MS diagram?
>>
>>
>> > --snip--
>> > Mr Bubb said:
>> >> ... hall sensor input and now that I think about it you ain't
>> >> using that anyway since you're going to be using a crank trigger.
>> >>
>> >
>> > How do you install a crank trigger on a vw motor?
>> >
>> > I am building a stroker 8V motor, and after seeing Timbo's
>> demonstration
>> > at
>> > Cincy, I am sure this is a cool project for me to do. By
>> trade I am an
>> > electronic tech, so wiring, soldering, etc is just about
>> second nature to
>> > me
>> > :-)
>> >
>> > Cheers.
>> >
>> > Marc
>> >
>> >
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>