[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

90mm vs 100mm - that is the question



Some tranny housing require clearancing on the passenger side shaft outlet in
order to install the 100mm flange. Not sure if its necessary on 4K, but it was
on my FN/FF.
Some pre-84 (?) hub carriers won't accept a 100mm outer cv assembly without
clearancing.
HTH
Al
 

> -----Original Message-----
> From: scirocco-l-bounces+amalventano1=tds.net@scirocco.org 
> [mailto:scirocco-l-bounces+amalventano1=tds.net@scirocco.org] 
> On Behalf Of Phil Boeye
> Sent: Saturday, January 28, 2006 5:20 PM
> To: Scirocco List
> Subject: 90mm vs 100mm - that is the question
> 
> QUESTION: 
> 
> Upgrading a 90mm driveshaft MK2 rocco (4K) to 100mm - does it 
> require any spindle clearancing?
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection 
> around http://mail.yahoo.com 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l