[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

(8v) are there different sized injector o-rings (or injector cups)?



I use my small pry bar for the install. Mostly cause it has an offset blade
at the end, which helps put the pressure in the right direction. I also
agree, smack it and it should get in there.  Jeff

----- Original Message -----
From: "Jeff Toomasson" <area53@validpath.com>
To: <scirocco-l@scirocco.org>
Sent: Friday, September 30, 2005 11:04 PM
Subject: Re: (8v) are there different sized injector o-rings (or injector
cups)?


> Anyone? I'm really stumped on this one. I put as much elbow grease as I
> felt was safe on this (a lot) and there wasn't so much as a budge...   :(
>
> This is my last weekend to work on this (our daughter is coming via
> scheduled c-section next Friday! :)  And I DON'T have a garage... :(
>
> http://validpath.com/images/81s/oring1.JPG
> http://validpath.com/images/81s/oring2.JPG
>
> thx again - JT
>
> Jeff Toomasson wrote:
>
> > Just dropped a new set of viton o-rings on my set of CIS lines. I'm
> > trying to get them into a 8v hydro head w/ black injector cups of
> > unknown origin. So far I've ZERO success getting them seat. I've tried
> > lubing them w/ carb cleaner, then a tiny bit of engine oil, but still
> > nothing close. Anyone have any ideas?
> >
> > Thanks!
> >
> > JT
> >
> >
>
>
> --
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.344 / Virus Database: 267.11.9/116 - Release Date: 9/30/2005
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>