ahhh! make it stop

[desinor at sympatico.ca (Jean-Claude Desinor)]

   There are two ways you can spot the loose pins:
   - hold the board steady and gently try to wiggle each pin. They 
should not move
   - use an 8X photo magnifier, you can then see the small cracks in the 
solder.

	Jean-Claude

Gretsch60s@aol.com a ?crit :
> In a message dated 11/16/05 12:59:33 AM Eastern Standard Time, 
> scirocco-l-request@scirocco.org writes:
> 
> thanks for the great info jean-claude!  The description of the L shaped board 
> was just the pointer I was looking for.  I knew something needed to be 
> soldered again. I'm gonna go over that area and re-heat some questionable areas, and 
> hopefully it will meld again.

>>ahhh! make it stop