[VWC] Oil pan bolt question and a 16V parts needed question

[johncworden at verizon.net (John C. Worden)]

I will look at getting some of these tomorrow.  If I have no luck with that 
I will
probably grind down the socket I was using since it was(luckily in this case)
and oddball cheapy that found it's way into the tool chest.
Thank you, everyone, for your replies.

John


At 01:18 PM 4/3/05, Mark F. wrote:

>On Apr 3, 2005 5:49 AM, John C. Worden <johncworden@verizon.net> wrote:
> > I had to take the pan off on the 16V and I've got it back on, except I
> > don't have the two bolts
> > that are closest to the transmission on.  They weren't on when I took the
> > pan off either, but
> > I would like to have them on there.  Any tips for getting them on there?  I
> > have tried the 1/4"
> > drive ratchet with socket and extension and it is too big to fit in
> > there.  Is there a special tool
> > for this?
>
>
>Here's what I did - replace the bolts with an allen head bolt!  :)
>
>MUCH easier...
>
>Later,
>
>Mark.
>
>
>
>--
>No virus found in this incoming message.
>Checked by AVG Anti-Virus.
>Version: 7.0.308 / Virus Database: 266.9.1 - Release Date: 4/1/05




-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.1 - Release Date: 4/1/05