engine Q's 2.0 guts in 1.8 block?

[ansonivan at yahoo.com (Anson Clement)]

Ah piss, thats what I was afraid of.... probably cheaper to just buy the real deal.
 
Thanks though
 
Anson

marc_scirocco <marc_scirocco@sympatico.ca> wrote:
The intermediate shaft needs to be clearanced as well. The far end diameter
needs to to be machined down.

Cheers.

Marc



> Dunno about the intermediate shaft though.
> Dan
> 
> ----- Original Message -----
> From: "Anson Clement" 
> To: 
> Sent: Sunday, September 19, 2004 2:10 PM
> Subject: engine Q's 2.0 guts in 1.8 block?
> 
> 
> > I have a good set of 2.o 16v internals and a 1.8 block 
> which could be 
> > bored. What sort of clearence issues will I encounter.
> >
> > I have heard that the intermediate shaft may need to be turned to a 
> > smaller diameter to clear the rods...
> > dunno if it's true.
> >
> > Just trying to be cheap.
> >
> > anson
> >


_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l


		
---------------------------------
Do you Yahoo!?
Yahoo! Mail - You care about security. So do we.