oil cooler O-ring

[Wolfsbrg8v at aol.com (Wolfsbrg8v@aol.com)]

If I had a short center pipe to replace the 3" one on there now, 
that would work.  (The cooler fits over the center pipe, and then 
the filter attaches at the bottom end.)

I did pull the seal out of a new Bosch filter, and it is twice the 
thickness of the old squashed one.  But, it is not actually an 
O-ring, it has a ribbon profile.  I believe I will wait til tomorrow 
and do this job right.

leo



SailingFC@aol.com wrote:

> Don't know your exact setup, but what about leaving the cooler off 
> completely 
>  and just spinning on a new filter?  Then drive it until you can get a new 
>  O-ring.