Scirocco-l Digest, Vol 11, Issue 3

[SCIROCCO75 at aol.com (SCIROCCO75@aol.com)]

In a message dated 3/3/04 1:10:44 PM Eastern Standard Time, 
scirocco-l-request@scirocco.org writes:
I just had a new header and rear motor mount installed.   
Prior to this I didn't notice the vibration nearly as much.
Hey if you installed a Monza header from jcwhitney, it probably is hitting 
the underbody, I have found that they are bent too aggressivly upward just near 
the collector, I had the same problem on my Cabby and also had replaced all 
the mounts, I ended up loosening all the mounts, and using a BIG bar I pryed the 
engine so the exhaust was away from the underbody and had a helper retighten 
all the mounts, it almost fixed it, we ended up heating the entire collector 
area red hot and bending downward. This was a common 4 into 1 header, check it 
out! Michael