[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
seating injectors
E.Noval wrote:
>
> I got some new injector seals, cleaned my injectors.
> Does anyone have advice on re-seating them?
>
> They need to go in about 1/2 inch, but they don't seem to want to
> seat without some serious pressure or lube of some sort.
>
> Any advice?
I've found that the easiest thing to do is use a large slot screwdriver
and tap it (lightly) with a hammer until it seats (hold the screwdriver
upright, resting the tip on the flat top surface where the line meets
the injector). Also, make sure you soak the new o-rings in gasoline to
lube them up. Take your time, and after it's seated make sure you look
with a light and mirror to make sure the o-ring is seated ok and not
pinched... Sometimes old injector bosses become smaller on the inside
(buildup of crap over time, or heat shrinkage, I dunno) which makes it
almost impossible to use new injector seals without ripping/pinching
them. I usually replace the bosses at the same time as the seals...
HTH,
Mark.
75
77
80 S
81 S
81 S 2.0 ABA/JH