Headlight wiring (connector) question...

[rhock99 at epix.net (Ryan H)]

anyone know where to find these?

> Alright, thanks guys... now, where can I pick up new connectors (metal) for use inside the plastic connectors?   Seem like normal spade quick connects, only larger.  Any part numbers or guidance appreciated.

> > 
> > From: "L F" <rocco16v@netzero.net>
> > Date: 2004/02/15 Sun PM 09:17:14 EST
> > To: "Ryan H" <rhock99@epix.net>,  <scirocco-l@scirocco.org>
> > Subject: Re: Headlight wiring (connector) question...
> > 
> > Yes, each spade connector has a little, rear-facing 'barb' on it that locks it into the plastic.  If you can slip a very thin (I used an Xacto 'chisel' blade IIRC) knife or screwdriver down from the FRONT to force the barb down, you can then pull the connector out from the back.
> >  It will clip right back in again if you need to re-install it.
> > 
> > Larry
> >   ----- Original Message ----- 
> >   From: Ryan H 
> >   To: scirocco-l@scirocco.org 
> >   Sent: Sunday, February 15, 2004 5:04 PM
> >   Subject: Headlight wiring (connector) question...
> > 
> > 
> >   I have a set of adapters for H4 headlight bulbs (to reverse the polarity).  My question is, is it possible to remove the wire from the plastic connector?  It looks like it can be done, cuz the wire/metal connectors are loose within the plastic connector, but I can't seem to jimmy it out of there.  Sorry for the bad descriptions...
> > 
> > 
> >   _______________________________________________
> >   Scirocco-l mailing list
> >   Scirocco-l@scirocco.org
> >   http://neubayern.net/mailman/listinfo/scirocco-l
> > 
> > 
> > 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 
>