[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
12 Point triple-square drive bit for axle flange
- Subject: 12 Point triple-square drive bit for axle flange
- From: juliemac57 at hotmail.com (Julie Macfarlane)
- Date: Wed Apr 28 07:28:08 2004
I got a set of the 3 at NAPA for $15.00. Try there.
Julie Macfarlane
1981 MKI 2L 16v w 2Y
"For good health : EAT RICE!"
Amsterdam NY
>From: "Rick Kellner" <rfkellner@snet.net>
>To: <scirocco-l@scirocco.org>
>Subject: RE: 12 Point triple-square drive bit for axle flange
>Date: Wed, 28 Apr 2004 06:30:43 -0400
>
>Is this bit readily available at Sears? I know GAP has them however; I
>would prefer not to pay shipping for one small item.
>Thanks, Rick.
>
>-----Original Message-----
>From: scirocco-l-bounces@scirocco.org
>[mailto:scirocco-l-bounces@scirocco.org] On Behalf Of T Berk
>Sent: Wednesday, April 28, 2004 2:03 AM
>Cc: scirocco-l@scirocco.org
>Subject: Re: 12 Point triple-square drive bit for axle flange
>
>Jeff Toomasson wrote:
>
> >
> >>Are the 12 point triple-square bolts that hold on the axle drive
>flange 8mm
> >>or 10mm? I know the head bolts are 12mm so that bit won't be of help.
>
> >>Thanks, Rick.
> >>_________
>
>
> > That would be 8mm...
> >
> > JT
> >
>
>I concur.
>
>I am given to understand out of the four pack of common sizes the 10 mm
>is used to remove certain vw 'HUBCAPS'.
>
>One thing that has helped me is to:
>
>- Get a bunch of long 3/8" extensions.
>
>- Get a deep socket 1/2" er socket. Gaf tape the 8 mm driver to it as a
>semi permanent install. This will make sense after you get started.
>
>- Use a screw driver in the vented part of the brake disk to prevent the
>
>axle from rotating. It holds up against the brake caliper. If
>non-vented, you can vice grip the thing or a helper can hold the
>tire/rim/wheel package while you work from under the car.
>
>- Be sure to spray some brake cleaner into the socket heads of the CV
>joints fasteners. Be sure to tap the 8mm firmly into the heads before
>you go torquing on stuff, else you strip the damn things.
>
>- Use a 3/8" drive breaker bar, not your ratchet, to break the hold
>those fasteners have. The ratchet can come into play right after you
>'snap' the things loose.
>
>
>hth,
>TBerk
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
_________________________________________________________________
Lose those love handles! MSN Fitness shows you two moves to slim your waist.
http://fitness.msn.com/articles/feeds/article.aspx?dept=exercise&article=et_pv_030104_lovehandles