Rebuilding with molly lub

[falzsf at mts.net (shawn f)]

Awesome, yes i will prime pump and engine. I have the tool that goes where your distributor goes to prime the oil system.
  ----- Original Message ----- 
  From: L F 
  To: shawn f 
  Cc: scirocco list 
  Sent: Saturday, September 27, 2003 7:35 AM
  Subject: Re: Rebuilding with molly lub


  Cam bearings and lobes
  balance shaft bearings
  main bearings
  rod bearings
  piston pins
  any other bearings I may have overlooked
  (don't forget to prime your new oil pump!)

  Larry
    ----- Original Message ----- 
    From: shawn f 
    To: L F 
    Cc: scirocco list 
    Sent: Friday, September 26, 2003 6:49 PM
    Subject: Re: Rebuilding with molly lub


    i was told to only put it on the top part.
      ----- Original Message ----- 
      From: L F 
      To: shawn f ; scirocco list 
      Sent: Friday, September 26, 2003 6:58 PM
      Subject: Re: Rebuilding with molly lub


      Use it everywhere there is a bearing, and on the cam lobes.
      Larry
        ----- Original Message ----- 
        From: shawn f 
        To: scirocco list 
        Sent: Friday, September 26, 2003 7:49 AM
        Subject: Rebuilding with molly lub


        What does everyone think of rebuilding the engine with molly lube? If yes where should i use it. I belive they say use iot on the top of the cam caps not sure where else though.
        _______________________________________________
        Scirocco-l mailing list
        Scirocco-l@scirocco.org
        http://neubayern.net/mailman/listinfo/scirocco-l