Any drawback to having a hydro head on a JH?

[rfkellner at snet.net (Rick Kellner)]

JT, does the solid lifter head have a different letter where the hydro
head has the "H"?
Thanks, Rick.

-----Original Message-----
From: Jeff Toomasson [mailto:jtoomasson@yahoo.com] 
Sent: Tuesday, September 16, 2003 5:11 PM
To: Rick Kellner; scirocco-l@scirocco.org
Subject: Re: Any drawback to having a hydro head on a JH?

Actually, Rick - that is typical for a solid lifter head (I have two in
my
garage  :).

The H for the hydraulic designation is located directly in the center of
the
front of the head on the same level as the part number. The part number
for
the hydro head is  026 103 373 F...

JT
----- Original Message ----- 
From: "Rick Kellner" <rfkellner@snet.net>
To: <scirocco-l@scirocco.org>
Sent: Tuesday, September 16, 2003 2:03 PM
Subject: RE: Any drawback to having a hydro head on a JH?


> Jeff, my 84 8v JH motor has a solid lifter head.  It also has an "H"
in
> the part number and at the end near the distributor.  The part number
is
> what you want to check.  Is it 026 103 373 H?
> Let's have a few more solid lifter listers check the part number.  Yes
I
> know looking it up on the CD is easier but no where near as much fun.
> Rick Kellner.
>
> -----Original Message-----
> From: scirocco-l-bounces@scirocco.org
> [mailto:scirocco-l-bounces@scirocco.org] On Behalf Of Jeff Toomasson
> Sent: Tuesday, September 16, 2003 2:28 PM
> To: scirocco-l@scirocco.org
> Subject: Any drawback to having a hydro head on a JH?
>
> When I bought the Cali, I noticed that the head had the big H on it.
The
> PO says that the cylinder head had never been replaced so it could
very
> well be the first owner's doing.
>
> I checked the block this morning and it is indeed a JH.
>
> What would this do? My first inclination is that, assuming only the
head
> was replaced, if the engine's oil pump wasn't upgraded at the same
time,
> the smaller solid-lifter pump probably wouldn't generate enough oil
> pressure to allow the hydraulic valve train to operate properly.
>
> Or - maybe the engine was completely replaced with something out of an
> '85/6/7/8 8v and the only way to truly confirm if the oil pump is the
> right one is to crack open the oil pan, right?
>
> Sheesh - Only in a Scirocco!   :)
>
> JT
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l