[tech] lower chassis dimensions

[JestersG60 at worldnet.att.net (Eric Lonchambon)]

Mr Bentley say   683 +/-  2mm . OR  26 7/8ths inches between front
subframe(dimension 'a')
section  8.1 Body and Interior page 44
-----Original Message-----
From: Foxx (in a box) <foxxinabox@excite.com>
To: txrocco@sbcglobal.net <txrocco@sbcglobal.net>; scirocco-l@scirocco.org
<scirocco-l@scirocco.org>
Date: Wednesday, May 14, 2003 11:59 PM
Subject: Re: [tech] lower chassis dimensions


>
>well foxx, if you are going to do somethign custom,<br>why now grab a
measuring tape and slide under your car<br>and center  of the bolt being the
mark, measure the<br>distance betwene them and you would have
your<br>distance.<br><br>---
>
>  simply because i fear that my '86 might have stretched past the point of
where it should be. only reason i fear this is because my other '86 had it's
arm snap on the bottom which made for dangerous driving and creative
welding. i was looking to put it back into factory spec, not factory spec +
###. and i fixed my reply-to for you.
>
>--
> /\_/\    Foxx (in a box)
>< o o >   http://foxx.tripod.com
>  \ /
>   ?
>
>_______________________________________________
>Join Excite! - http://www.excite.com
>The most personalized portal on the Web!
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
>