[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
How to pull the hub off the bearing?
- Subject: How to pull the hub off the bearing?
- From: juliemac57@hotmail.com (Julie Macfarlane)
- Date: Tue, 04 Mar 2003 21:04:40 +0000
Are these the rear bearings?
I placed the rears by placeing the drum on a vice and tapping the bearing
out with a wide screwdriver very slowly around the inside.
Do this slowly and it will come out.
I used a 30mm socket as a press.
have fun!
Julie Macfarlane
Menlo Park Research & Development
Internet Application Developer
www.menloparkrandd.com
www.montgomeryweb.org
Amsterdam NY
>From: "Tobias ><" <scirocco16v88@hotmail.com>
>To: scirocco-l@scirocco.org
>Subject: How to pull the hub off the bearing?
>Date: Tue, 04 Mar 2003 20:50:15 +0000
>
>
>I'm going to replace the wheel bearings myself, but I need to know if there
>is a patented Cheapass method of pulling the Hub of the Bearing - or do I
>need one of those fancy hub pullers?
>
>I do not intend to remove the hub and bearing assembly from the car - I'm
>going to change the bearing while the bearing housing is still attached.
>I'm going to use a bearing puller installer tool for this.
>
>Thanks,
>T
>
>_________________________________________________________________
>The new MSN 8: advanced junk mail protection and 2 months FREE*
>http://join.msn.com/?page=features/junkmail
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l
_________________________________________________________________
Protect your PC - get McAfee.com VirusScan Online
http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963