anyone have a pic of mounting points for 16v K-bar?

[txrocco at sbcglobal.net (Patrick Bureau)]

Unless you ave a 90' drill head :)

--- Joe Doty <Joe.Doty@lcnetwork.com> wrote:
> I had pretty good luck drilling a small pilot hole
> first to use as an
> index, then drill the larger hole in relation to the
> small one.  Don't
> bother trying from up top...it will just make you
> hate yourself.
> 
> Joe Doty
> IT/Development
> joe@lcnetwork.com 
> 
> > It can be done with the motor installed. its
> tricky though. i did it
> on my
> > cabby. you have to drill from the bottom, BUT
> hitting the spot where
> the
> > 4pt holes are is not that easy, i just took like a
> c-clamp or
> something,
> > and came from the bottom, and put the other end in
> the top hole of the
> 4pt
> > bar.  and i marked the spot underneath. It was a
> direct hit for me.
> you
> > can try that or think of another way similar that
> might work better
> for
> > you.
> > 
> > derek wiser
> > 
> > Jeff Toomasson <jtoomasson@yahoo.com> wrote:
> > thanks Derek - didn't think of that. Any chance
> you remember if it can
> be
> > done with a motor installed? (with respect drill
> angles, etc.)
> > 
> > thanks again, Jeff
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l


=====
ATS - Patrick Bureau - txrocco@sbcglobal.net
http://www.longcoeur.com/scirocco/
==============================
'85 2.0L Prowler orangeKamei X1 Rocco
'85 1.8L Titian Red Daily Driver Rocco
'98 4.0L Jeep Cherokee
'91 7.5L Diesel F250 Super cab w/8ft bed.