anyone have a pic of mounting points for 16v K-bar?

[vw_16v_desert_wind at yahoo.com (Derek Wiser)]

It can be done with the motor installed. its tricky though. i did it on my cabby. you have to drill from the bottom, BUT hitting the spot where the 4pt holes are is not that easy, i just took like a c-clamp or something, and came from the bottom, and put the other end in the top hole of the 4pt bar.  and i marked the spot underneath. It was a direct hit for me. you can try that or think of another way similar that might work better for you.
 
derek wiser

Jeff Toomasson <jtoomasson@yahoo.com> wrote:
thanks Derek - didn't think of that. Any chance you remember if it can be done with a motor installed? (with respect drill angles, etc.)
 
thanks again, Jeff
----- Original Message ----- 
From: Derek Wiser 
To: Jeff Toomasson ; scirocco-l@scirocco.org 
Sent: Tuesday, June 24, 2003 11:18 AM
Subject: Re: anyone have a pic of mounting points for 16v K-bar?


well, when you mount the 4pt bar to the front mounts of the control arm bolts, youll see where it sits on the frame. then you have to mark it and drill a hole for the to rear spots on the 4pt bar. I know this is kinda vague, but you should get the picture when you get it mounted to the front 2 points.
 
derek wiser

Jeff Toomasson <jtoomasson@yahoo.com> wrote:
I was thinking of tranferring this to my mk1 (which has a full 16v brake setup) and transferring my 2-point Neuspeed lower tie-bar to the cabby. But I can't for the life of me remember where the other two mounting points are.

Thanks in advance!

Jeff
_______________________________________________
Scirocco-l mailing list
Scirocco-l@scirocco.org
http://neubayern.net/mailman/listinfo/scirocco-l

---------------------------------
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!

---------------------------------
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!