[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Cam install
Shawn,
I believe that is what Kervin was talking about, a new cam:
"I've never put a un-used cam in before. Anything I need to do to it or
any break-in?"
Rick K.
-----Original Message-----
From: Shawn c Meze [mailto:skerocdriver@juno.com]
Sent: Saturday, June 14, 2003 10:00 PM
To: rfkellner@snet.net
Cc: scirocco-l@scirocco.org
Subject: Re: Cam install
On Sat, 14 Jun 2003 21:51:33 -0400 "Rick Kellner" <rfkellner@snet.net>
writes:
> I followed the procedure in Bentley and in G. Ravens book when I
> installed my new G-Cam (solid lifters). Use plenty of cam grease on
the
> lobes (never on the bearings). Start the motor immediately and keep
> it at 2k for twenty minutes. Do not crank it to build up oil
pressure.
> You want it to run right up to 2k.
> Rick Kellner.
OK, that's break in procedure on a NEW cam. Not necessary on a used cam.
Shawn M?ze
#30 2002 SDR Solo2 AS Champion. 86' Jetta GLi 8V 84' Scirocco 8V
82' Scirocco "Ruflus" 80' Scirocco S 79' "Project FSP Scirocco
The Fastest, Quickest, Cleanest and best looking Scirocco(s) in all of
San Diego!
http://www.Geocities.com/MotorCity/Speedway/1308/index.htm
________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!
- References:
- Cam install
- From: skerocdriver at juno.com (Shawn c Meze)